The UV lamp of the UV flatbed printer is one of the core components of the equipment. This component can ensure the rapid drying of the UV ink and avoid group discoloration. Long-term use will cause the aging of the UV lamp, and improper use will also cause problems. If you encounter problems, please refer to the following Several methods:

1. The UV lamp of uv flatbed printer is dimmed

A. Whether the knob on the water tank is changed, the solution: just twist the knob on the water tank;

B. The internal power supply of the water tank is damaged, the solution: open the water tank, which power line is short-circuited and burned, reconnect and repair it;

C. The UV power cord is damaged, the solution: just replace it with a new UV power cord;

D. The UV lamp belt is damaged, the solution: replace with a new uv lamp belt;

E. Poor contact, solution: if the interface is loose, re-tighten it;

F. The temperature is too high, the solution: check the refrigerant in the lower water tank and add a new one.

2. The UV lamp of the uv flatbed printer does not turn off

A. The Y board relay is aging, the solution: just replace the new Y board relay;

B. The software is not turned off to test the UV light, the solution: the software can be turned off for testing;

C. The UV control line is short-circuited, and the solution: replace the control line and reconnect it;

D. The board card is faulty, and the solution: just replace it with a new board card.

3. The UV light of the uv flatbed printer does not light up

A. The UV power cord is damaged, the solution: just replace it with a new UV power cord;

B. The UV lamp belt is damaged, the solution: replace with a new uv lamp belt;

C. The internal power supply of the water tank is damaged, and the solution: repair the damaged part of the internal power supply. If it cannot be repaired, contact the manufacturer to replace it with a new one;

D. The power output of the knob on the water tank is 0, the solution: adjust the output power of the lower knob.

E. The control software does not turn on the light, the solution: just turn on the control software light;

F. The lamp is damaged, the solution: contact the manufacturer and replace with a new uv lamp;

G. Board card failure, solution: contact the manufacturer and replace with a new board card;

4. The UV light illumination distance of the uv flatbed printer is wrong

A. The power cord of the UV lamp is connected reversely, the solution: the power cord of the UV lamp can be connected positively;

B. There is a problem with the light distance, the solution: adjust the light on the software.

Analyzing and troubleshooting according to the above several methods can ensure that the cause of the problem is found and the UV lamp failure can be solved quickly. If you want to know more about UV printers, please contact and follow the official website of GIBSON.

Hot tags: UV flatbed printer